Jlcooper Eclipse Ethernet 2.6 for OSX Instrukcja Użytkownika Pobierz pdf (Strona 13)

Hardware Setup

Eclipse Series modules with Ethernet need to have their IP address, subnet mask and

port set so that they are able to communicate on your network. Most of the following

setup information applies to all Eclipse Series modules that can operate standalone with

an Ethernet connection, such as the Eclipse CX, Eclipse CX Midnight, Eclipse SX

Midnight, and Eclipse MX-SA. For convenience, Eclipse will be used to refer to any of

these modules, except when the setup information is different for a particular module.

First, plug an ethernet cable into the back of the Eclipse then connect the other end of

the cable either directly to your Mac or to a router, switch or hub connected to your Mac.

If your Mac has two ethernet ports, use the ﬁrst one. Turn on the Eclipse.

Determining the Mac’s IP Address

The IP Address consists of four groups of numbers separated by periods. Each number

can be 1 to 3 digits, with a maximum value of 255, as in 192.168.1.6.

On your Mac, open the System Preferences, either from the Dock or from the Apple

Menu. Click on the Network icon.

On the left side of the window ﬁnd and select the ethernet port. If your Mac has two

ethernet ports the ﬁrst port (which is the one you should be connected to) will probably

be referred to as Built-in Ethernet.

Eclipse Ethernet Software

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 133 134

Brak uwag

Jlcooper Eclipse Ethernet 2.6 for OSX Instrukcja Użytkownika Strona 13