Jlcooper Eclipse Ethernet 2.6 for OSX Instrukcja Użytkownika Pobierz pdf (Strona 16)

Assigning an IP Address to the Eclipse SX Midnight

To assign the IP Address on a standalone Eclipse SX Midnight, press the Page 4 and

Page 8 buttons at the same time. The display will show:

Press Page 7 to set the IP Address and Port number. The display will show:

Use the knobs below each number to the unique address you created earlier. 23 is a

good choice for the port. Press Page 8 when you are done.

To set the IP mask, press Page 4 + Page 8 once again to access the conﬁguration

page. The right display will show:

Press Page 6 to set the IP subnet mask of the Eclipse SX Midnight. The displays will

show:

Use the knobs below each number to set the mask value you obtained from System

Preferences. Press Page 8 when you are done. In order for the new settings to take

effect, you must turn the Spectrum off and back on again.

Eclipse Ethernet Software

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 133 134

Brak uwag

Jlcooper Eclipse Ethernet 2.6 for OSX Instrukcja Użytkownika Strona 16